#include <Servo.h>

Servo myServo;           // Create a Servo object
const int servoPin = 10; // D10 is OC1B on Pro Mini
const int ledPin = 13;
const int analogPin = A0;

void setup() {
  pinMode(ledPin, OUTPUT);       
  Serial.begin(115200);            // Initialize Serial
  myServo.attach(servoPin);      // Attach servo to pin 10
}

void loop() {
  int analogValue = analogRead(analogPin); // Read from A0 (0–1023)
  int angle = map(analogValue, 0, 1023, 0, 180); // Map to 0–180 degrees

  myServo.write(angle);  // Set servo angle

  digitalWrite(ledPin, HIGH);
  // Serial.print("LED ON - Analog: ");
  // Serial.print(analogValue);
  // Serial.print(" | Angle: ");
  // Serial.println(angle);
  delay(10);

  digitalWrite(ledPin, LOW);
  // Serial.print("LED OFF - Analog: ");
  // Serial.print(analogValue);
  // Serial.print(" | Angle: ");
  // Serial.println(angle);
  delay(10);
}