/**
@page RCC_UseHSEasSystemClock RCC Clock Config example
@verbatim
******************** (C) COPYRIGHT 2016 STMicroelectronics *******************
* @file Examples_LL/RCC/RCC_UseHSEasSystemClock/readme.txt
* @author MCD Application Team
* @brief Description of the RCC HSE start example.
******************************************************************************
* @attention
*
* Copyright (c) 2016 STMicroelectronics.
* All rights reserved.
*
* This software is licensed under terms that can be found in the LICENSE file
* in the root directory of this software component.
* If no LICENSE file comes with this software, it is provided AS-IS.
*
******************************************************************************
@endverbatim
@par Example Description
Use of the RCC LL API to start the HSE and use it as system clock.
At start-up, HSI clock is used as system clock (default clock after reset) and then Systick is
configured at 1 ms using HSI_VALUE define.
Then, HSE is started and we wait for ready state. System clock is set to HSE thanks to IT
triggered by HSE ready.
- LED2 is turned ON to indicate that HSE is ready.
- LED2 is toggled with a timing of 1 second in case of error to switch SYSCLK to HSE or if HSE CSS
failure is detected (through NMI IT).
@note In HSE bypass mode, input clock will come from the MCO from
ST_LINK MCU. This frequency cannot be changed, and it is fixed
at 8 MHz. To use MCO from ST_LINK you need to check the Board
User Manual to know how to connect the MCO pin to the STM32 device.
@par Directory contents
- RCC/RCC_UseHSEasSystemClock/Inc/stm32f1xx_it.h Interrupt handlers header file
- RCC/RCC_UseHSEasSystemClock/Inc/main.h Header for main.c module
- RCC/RCC_UseHSEasSystemClock/Inc/stm32_assert.h Template file to include assert_failed function
- RCC/RCC_UseHSEasSystemClock/Src/stm32f1xx_it.c Interrupt handlers
- RCC/RCC_UseHSEasSystemClock/Src/main.c Main program
- RCC/RCC_UseHSEasSystemClock/Src/system_stm32f1xx.c STM32F1xx system source file
@par Hardware and Software environment
- This example runs on STM32F103xB devices.
- This example has been tested with STM32F103RB-Nucleo
board and can be easily tailored to any other supported device
and development board.
@par How to use it ?
In order to make the program work, you must do the following :
- Open your preferred toolchain
- Rebuild all files and load your image into target memory
- Run the example
*/
5326afcfb2